padsterew.blogg.se - How to use facerig for the first time

#How to use facerig for the first time how to
#How to use facerig for the first time install
#How to use facerig for the first time series

This command reloads the operating system. Step 4 Enter reload when the following CLI message displays: Erase of nvram: complete. Step 3 Enter Y when the following CLI message displays: Erasing the nvram filesystem will remove all configuration files! Continue?. Step 2 Follow the step below to erase a static IP address and subnet mask. Note The erase nvram command does not erase a static IP address.

Step 1 Enter erase nvram: to erase all NVRAM files including the startup configuration. If you want to erase everything including the static IP address, in addition to the above commands, use the erase and erase boot static-ipaddr static-ipmask command.įrom the privileged EXEC mode, you can reset the access point/bridge configuration to factory default values using the CLI by following these steps: If you want to reset the access point to its default settings and a static IP address, use the write erase or erase /all nvram command. Resetting to Default Settings Using the CLIĬaution You should never delete any of the system files prior to resetting defaults or reloading software. Resetting to Default Settings Using the GUI If you need to start over during the initial setup process, you can reset the access point to factory default settings.Resetting to Default Settings Using the MODE Button

A Simple Network Management Protocol (SNMP) community name and the SNMP file attribute (if SNMP is in use).

If the wireless device is not on the same subnet as your PC, a default gateway address and subnet mask.

The case-sensitive wireless service set identifier (SSID) for your radio network.

#How to use facerig for the first time install

Note In this release, the access point radio interfaces are disabled by default.īefore you install the wireless device, make sure you are using a computer connected to the same network as the wireless device, and obtain the following information from your network administrator:

#How to use facerig for the first time series

Connecting to the 1300 Series Access Point/Bridge Locally.You can configure all the settings described in this chapter using the CLI, but it might be simplest to browse to the wireless device web-browser interface to complete the initial configuration and then use the CLI to enter additional settings for a more detailed configuration. The contents of this chapter are similar to the instructions in the quick start guide that shipped with the wireless device.

#How to use facerig for the first time how to

This chapter describes how to configure basic settings on the wireless device for the first time.